Cruise Control Combination Switch Removal, Installation, and Test
SRS components are located in this area. Review the SRS component locations, 2-door, 4-door and the precautions and procedures before doing repairs or service.
1.
Cruise Control Combination Switch - Remove
1.
Adjust the steering column to the full tilt up position, and to the full telescopic out position.
2.
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
3.
Turn the steering wheel 90 degrees counterclockwise, and then remove the screws (A).
4.
Turn the steering wheel 90 degrees clockwise.
5.
Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
Measure the resistance between cruise control combination switch 12P connector terminals No. 2 and No. 5 according to the table.
If there is no resistance in one or more positions, replace the cruise control combination switch.
Position
Resistance
OFF
About 2.2 k?
Cruise control main (PRESSED)
About 60 ?
Cancel (PRESSED)
About 190 ?
Set/- (PRESSED)
About 450 ?
Res/+ (PRESSED)
About 900 ?
2.
Check the LED for illumination by applying power and ground to the terminals according to the table.
NOTE: Important operating characteristic; diode bias cause a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
If the results are not as specified, replace the cruise control combination switch.
SRS components are located in this area. Review the SRS component locations, 2-door, 4-door and the precautions and procedures before doing repairs or service.
1.
Cruise Control Combination Switch - Install
1.
Install the cruise control combination switch (A).
