Fuel Tank Removal and Installation
2. Middle Floor Undercovers - Remove

Remove the middle floor undercovers.

3. Exhaust Pipe B - Remove

Remove exhaust pipe B.

4. Left Rear Inner Fender - Remove

Remove the left rear inner fender.

5. Fuel Fill Pipe - Disconnect

USA and Canada models

Mexico models
1.
USA and Canada models: Remove the cover (A).
2.
Disconnect the fuel line quick-connect fittings (B) or the hoses (C). When you are disconnecting the hose, slide back the clamp, then twist the hose as you pull to avoid damaging it.

6. Fuel Tank Assembly - Remove

USA and Canada models

Mexico models
1.
Remove the hose (A) from the clamp, and disconnect the fuel vapor hose (B).
2.
Remove the fuel tank protector (A) from the fuel tank.
3.
Remove the parking brake cable mounting bolts (A).
4.
Place a jack or other support under the fuel tank (B).
5.
Remove the straps (C) and the fuel tank carefully.

1. Fuel Tank Assembly - Install
1.
Place a jack or other support under the fuel tank (A).
2.
Install the straps (B) and the fuel tank carefully.
3.
Install the parking brake cable mounting bolts (C).
4.
Install the fuel tank protector (A) to the fuel tank.
NOTE: Make sure to insert it into the clip (B) in the direction shown.




USA and Canada models

Mexico models
5.
Connect the fuel vapor hose (A), and install the hose (B) to the clamp.

2. Fuel Fill Pipe - Connect

USA and Canada models

Mexico models
1.
Connect the fuel line quick-connect fittings (A) or the hoses (B).
2.
USA and Canada models: Install the cover (C).

3. Left Rear Inner Fender - Install

Install the left rear inner fender.

4. Exhaust Pipe B - Install

Install exhaust pipe B.

5. Middle Floor Undercovers - Install

Install the middle floor undercovers.

6. Fuel Line Quick-Connect Fitting - Connect
Connect the quick-connect fitting (A) to the fuel tank unit.


7. Fuel Leak - Check
1.
Connect the fuel tank unit connector (A).
2.
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode (but do not operate the starter motor). The fuel pump runs for about 2 seconds, and fuel pressure rises. Repeat this two or three times, then make sure there are no fuel leaks.

8. Fuel Tank Unit Access Panel - Install
Install the access panel (A) to the floor.


9. Rear Seat Cushion - Install

Install the rear seat cushion.