Front Impact Sensor Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Battery Terminal - Disconnect

Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2. Front Bumper Upper Air Duct - Remove

Remove the front bumper upper air duct.

3. Front Impact Sensor - Remove
1.
Remove the TORX bolt (A) using a TORX T30 bit, then remove the front impact sensor (B).
2.
Disconnect the front impact sensor connector (C) on the engine compartment wire harness.


SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Front Impact Sensor - Install
1.
Connect the front impact sensor connector (A) on the engine compartment wire harness.
2.
Install the front impact sensor (B) with the new TORX bolt (C), using a TORX T30 bit.

2. Battery Terminal - Connect

Do the battery terminal reconnection procedure.

3. DTC - Clear

Clear any DTCs with the HDS.

4. SRS Operation - Confirm

Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.

5. Front Bumper Upper Air Duct - Install

Install the front bumper upper air duct.