DTC Troubleshooting: C1040-00
DTC C1040-00: Wheel Speed Signal Error
NOTE:
Before you troubleshoot, review the general troubleshooting information.
Check the tires for proper inflation and the correct size.
Make sure the suspension is not modified.
Check the wheel alignment, and adjust it if necessary.

DTC Description
DTC
Freeze Frame
C1040-00 Wheel Speed Signal Error
    

1.
VSA system DTCs check:

VSA system DTCs check
?1.
Turn the vehicle to the ON mode.

?2.
Check for VSA system DTCs with the HDS.
DTC Description
DTC
Freeze Frame
     

Are any DTCs indicated?

     
YES
     
     
     
     
NO
     
     
     
Go to step 2.
2.
Problem verification:

Problem verification
?1.
Turn the vehicle to the ON mode.

?2.
Clear the DTC with the HDS.


?3.
Turn the vehicle to the OFF (LOCK) mode.

?4.
Test-drive the vehicle in a straight line at speeds 25 mph (40 km/h) or more for 30 seconds or more with the LKAS activated.
NOTE: Drive the vehicle on the road, not on a lift.

?5.
Check for DTCs with the HDS.
DTC Description
DTC
Freeze Frame
C1040-00 Wheel Speed Signal Error
    

Is DTC C1040-00 indicated?

     
YES
     
     
     
Check for loose terminals and poor connections in the multipurpose camera unit 20P connector. If they are OK, replace the multipurpose camera unit.?
     
NO
     
     
     
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.?