| 1*1 | GND | Ground for gauge control module | Less than 0.2 V at all times | 
| 2*3 | INFO GND | Ground for select/reset/information switch | Less than 0.2 V at all times | 
| 3*1*2 | ILL-(LED) | Outputs ILL-(LED) signal | ??? | 
| 3*3*8 | OUTSIDE TEMP GND | Ground for outside air temperature sensor | Less than 0.2 V at all times | 
| 4 | PARKING BRAKE SW | Detects PARKING BRAKE SW signal | With the vehicle in the ON mode and parking brake switch OFF: about battery voltageWith the vehicle in the ON mode and parking brake switch ON: less than 0.2 V
 | 
| 5*1*2 | ILLUMI-(BULB) | Outputs ILLUMI-(BULB) signal | ??? | 
| 6 | BRAKE LEVEL SW | Detects BRAKE LEVEL SW signal | With the vehicle in the ON mode and brake fluid level switch OFF: about battery voltageWith the vehicle in the ON mode and brake fluid level switch ON: less than 0.2 V
 | 
| 7*4 | WASHER LEVEL SNSR | Detects WASHER LEVEL SNSR signal | With the vehicle in the ON mode and washer fluid level switch OFF: about battery voltageWith the vehicle in the ON mode and washer fluid level switch ON: less than 0.2 V
 | 
| 8*5 | VSA OFF SW | Detects VSA OFF SW signal | With the vehicle in ON mode and VSA off switch OFF: about battery voltageWith the vehicle in ON mode and VSA off switch ON: less than 0.2 V
 | 
| 9*6 | ILLUMI CANCEL | Outputs ILLUMI CANCEL signal | With combination light switch in PARKING and illumination full brightness: less than 0.2 VIf none of the above conditions are met: about 3 V
 | 
| 9*7 | CMBS OFF SW | Detects CMBS OFF SW signal | With the vehicle in the ON mode and CMBS off switch OFF: about battery voltageWith the vehicle in the ON mode and CMBS off switch ON: less than 0.2 V
 | 
| 10 | Not used | ??? | ??? | 
| 11 | FUEL GAUGE+ | Detects FUEL GAUGE+ signal | ??? | 
| 12*3 | INFO SW | Detects INFO SW signal | With the vehicle in the ON mode: about 0.8?4.4 V (depending on select/reset/information switch) | 
| 12*2*8 | TAM | Detects TAM signal | With the vehicle in the ON mode: about 0.2?4.9 V (depending on outside air temperature sensor) | 
| 13*3*8 | TAM | Detects TAM signal | With the vehicle in the ON mode: about 0.2?4.9 V (depending on outside air temperature sensor) | 
| 14*9*10 | CRUISE SW | Detects CRUISE SW signal  | With the vehicle in the ON mode: about 0.8?4.4 V (depending on ACC/cruise control combination switch) | 
| 15 | IG1 METER | IG1 power source | With the vehicle in the ON or START mode: about battery voltage | 
| 16 | +B BACK UP | Power source for gauge control module | About battery voltage at all times | 
| 17 | GND | Ground for gauge control module | Less than 0.2 V at all times | 
| 18 | FUEL GAUGE- | Ground for fuel gauge sending unit | ??? | 
| 19*9*10 | CRUISE GND | Ground for ACC/cruise control combination switch | Less than 0.2 V at all times | 
| 20*2*8 | OUTSIDE TEMP GND | Ground for outside air temperature sensor | Less than 0.2 V at all times | 
| 20*10 | DISTANCE SW GND | Ground for ACC combination switch | Less than 0.2 V at all times | 
| 21 | F-CAN_H*11F-CAN A_H*12
 | Communication line | ??? | 
| 22 | F-CAN_L*11F-CAN A_L*12
 | Communication line | ??? | 
| 23 | B-CAN_H | Communication line | ??? | 
| 24 | B-CAN_L | Communication line | ??? | 
| 25*13 | TPMS SW | Detects TPMS SW signal | With the vehicle in the ON mode and TPMS switch OFF: about battery voltageWith the vehicle in the ON mode and TPMS switch ON: less than 0.2 V
 | 
| 26*2*14 | ECON SW | Detects ECON SW signal | With the vehicle in the ON mode and ECON switch OFF: about battery voltageWith the vehicle in the ON mode and ECON switch ON: less than 0.2 V
 | 
| 26*10 | DISTANCE SW | Detects DISTANCE SW signal  | With the vehicle in the ON mode: about 0.8?4.4 V (depending on ACC combination switch) | 
| 27*3*14 | ECON SW | Detects ECON SW signal | With the vehicle in the ON mode and ECON switch OFF: about battery voltageWith the vehicle in the ON mode and ECON switch ON: less than 0.2 V
 | 
| 28 | Not used | ??? | ??? | 
| 29 | Not used | ??? | ??? | 
| 30 | Not used | ??? | ??? | 
| 31*3 | ILL-(LED) | Outputs ILL-(LED) signal | ??? | 
| 32*3 | ILLUMI-(BULB) | Outputs ILLUMI-(BULB) signal | ??? |