Moonroof Frame and Drain Tube Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:
Before installing the frame, clear the drain tubes and the drain valves using compressed air.
To install a new drain tube, tie the string left in the body during drain tube removal to the top end of the new drain tube, and pull it up into the roof.
When connecting the drain tubes, slide them over the frame nozzles at least 10 mm (0.39 in).
Check the frame seal.
Install the tube clips (A) on the drain tubes (B) as shown.

Moonroof Frame

2. These Items - Remove (if necessary)

If necessary, remove these items.

3. Moonroof Frame - Remove
1.
Disconnect the connector (A).
2.
Remove the harnesses clips (B).
3.
Disconnect the front drain tubes (A) and the rear drain tubes (B).




4.
Remove the bolts and release the hook (A), with the help of an assistant, then remove the frame (B).
NOTE: Have an assistant help you when removing the moonroof frame.
5.
If necessary, remove the frame seals (A) from the frame (B).
NOTE: Make sure the frame seals line up with the alignment marks (C).

4. All Removed Parts - Install

1.
Install the parts in the reverse order of removal.

Front Drain Tube

3. Front Drain Tube - Remove
1.
Pull the front drain valve (A) out of the body hole.
2.
Tie a string to the top end of the front drain tube (B), then pull the drain tube down out of the pillar. Leave the string in the pillar to use when reinstalling the drain tube.

4. All Removed Parts - Install

1.
Install the parts in the reverse order of removal.

Rear Drain Tube

2. Rear Drain Tube - Remove
1.
Remove the clips (A).
2.
Pull the rear drain valve (B) out of the body hole.
3.
Tie a string to the top end of the rear drain tube (C), then pull the drain tube down out of the pillar. Leave the string in the pillar to use when reinstalling the drain tube.

3. All Removed Parts - Install

1.
Install the parts in the reverse order of removal.