A/C Refrigerant Recovery/Evacuation/Charging
Special Tools Required
Image Description/Tool Number
13793833.png R-1234yf A/C Recover/Recycle/Recharge Machine ROB421234*
13793836.png R-1234yf POE Oil Injector ROB18470*
*These tools are available through the Honda Tool and Equipment Program; call 888-424-6857.
Compressed air mixed with the HFO-1234yf (R-1234yf) forms a combustible vapor.
The vapor can burn or explode causing serious injury.
Never use compressed air to pressure test HFO-1234yf (R-1234yf) service equipment or vehicle air conditioning systems.
Air conditioning refrigerant or lubricant vapor can irritate your eyes, nose, or throat.
Be careful when connecting service equipment.
Do not breathe refrigerant or vapor.

NOTE:
If accidental system discharge occurs, ventilate the work area before resuming service.
Additional health and safety information may be obtained from the refrigerant and lubricant manufacturers.
Do not allow moisture to contaminate the A/C system oil. Moisture in the oil is difficult to remove, and it can damage the A/C compressor.
Air conditioning refrigerant is poisonous. If ingested, get medical attention immediately.

When an A/C system has been opened to the atmosphere, such as during installation or repair, it must be evacuated using an A/C recover/recycle/recharge machine. If the system has been open for several days, replace the receiver/dryer or the desiccant, drain the refrigerant oil, and add fresh oil. Then evacuate the system for several hours before charging it.

1. A/C Recover/Recycle/Recharge Machine - Connect
1.
Connect an A/C recover/recycle/recharge machine to the high-pressure service port (A) and the low-pressure service port (B), as shown, following the equipment manufacturer's instructions.

2. A/C Refrigerant - Recover
1.
Recover the refrigerant from the A/C system.
2.
Measure the amount of refrigerant oil removed from the A/C system after the recovery process is completed. Be sure to put the same amount of new refrigerant oil back into the A/C system before charging.
 

3. A/C System - Evacuate
1.
Evacuate the system. The vacuum pump should run for a minimum of 30 minutes or until the moisture vacuum test passes, to eliminate all moisture from the system. When the suction gauge reads ?93.3 kPa (?700 mmHg, ?27.55 inHg) for at least 30 minutes, or the moisture vacuum test passes, close all valves, and turn off the vacuum pump.
2.
If the suction gauge does not reach approximately ?93.3 kPa (?700 mmHg, ?27.55 inHg) in 15 minutes or the moisture vacuum test fails, there is probably a leak in the system. Partially charge the system, and check for leaks.
 

5. A/C Refrigerant - Charge
1.
Charge the system with the specified amount of R-1234yf refrigerant. Do not overcharge the system; the A/C compressor will be damaged.
Select the appropriate units of measure for your refrigerant A/C recover/recycle/recharge machine.
Refrigerant Capacity:
375 to 425 g
13.23 to 15.00 oz
0.375 to 0.425 kg
0.827 to 0.937 lbs