DTC Troubleshooting: B00C1-87

DTC B00C1-87: No Signal From the Front Passenger's Weight Sensor (front outer side)

NOTE:

	Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number and were properly installed.
	Before doing this troubleshooting procedure, review SRS Precautions and Procedures, General Troubleshooting Information, and 12 Volt Battery Terminal Disconnection and Reconnection.

DTC Description	DTC
B00C1-87 No signal from the front passenger's weight sensor (front outer side)

Problem verification:

Problem verification

?1.	Clear the DTCs with the HDS.

?2.	Turn the vehicle to the ON mode, then wait for 10 seconds.

?3.

Check for DTCs with the HDS.

DTC Description	DTC
B00C1-87 No signal from the front passenger's weight sensor (front outer side)

Is DTC B00C1-87 indicated?


	YES

The failure is duplicated. Go to step 2.


	NO

Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.?

Open wire check (SWS?/SWSP3 line):

Open wire check (SWS?/SWSP3 line)

?1.	Turn the vehicle to the OFF (LOCK) mode.

?2.	Disconnect the negative cable from the 12 volt battery, then wait at least 3 minutes.

?3.

Disconnect the following connectors.

SRS unit connector B (39P)

Front passenger's weight sensor (front outer side) 3P connector (on the front passenger's seat wire harness)

?4.

Measure the resistance between test points 1 and 2.

Test condition	Vehicle OFF (LOCK) mode
	SRS unit connector B (39P): disconnected
	Front passenger's weight sensor (front outer side) 3P connector (on the front passenger's seat wire harness): disconnected
Test point 1	SRS unit connector B (39P) No. 26
Test point 2	Front passenger's weight sensor (front outer side) 3P connector (female terminals) No. 1 (on the front passenger's seat wire harness):

Is there 1.0 ? or less?


	YES

The SWS?/SWSP3 wire is not open. Go to step 3.


	NO

Open in the floor wire harness or the front passenger's seat wire harness; replace the faulty harness, then clear the DTC.?

Open wire check (SWS?/SWS3G line):

Open wire check (SWS?/SWS3G line)

?1.

Measure the resistance between test points 1 and 2.

Test condition	Vehicle OFF (LOCK) mode
	SRS unit connector B (39P): disconnected
	Front passenger's weight sensor (front outer side) 3P connector (on the front passenger's seat wire harness): disconnected
Test point 1	SRS unit connector B (39P) No. 28
Test point 2	Front passenger's weight sensor (front outer side) 3P connector (female terminals) No. 3 (on the front passenger's seat wire harness):

Is there 1.0 ? or less?


	YES

The SWS?/SWS3G wire is not open. Go to step 4.


	NO

Open in the floor wire harness or the front passenger's seat wire harness; replace the faulty harness, then clear the DTC.?

Open wire check (SWSS/SWS3 line):

Open wire check (SWSS/SWS3 line)

?1.

Measure the resistance between test points 1 and 2.

Test condition	Vehicle OFF (LOCK) mode
	SRS unit connector B (39P): disconnected
	Front passenger's weight sensor (front outer side) 3P connector (on the front passenger's seat wire harness): disconnected
Test point 1	SRS unit connector B (39P) No. 30
Test point 2	Front passenger's weight sensor (front outer side) 3P connector (female terminals) No. 2 (on the front passenger's seat wire harness):

Is there 1.0 ? or less?


	YES

The SWSS/SWS3 wire is not open. Go to step 5.


	NO

Open in the floor wire harness or the front passenger's seat wire harness; replace the faulty harness, then clear the DTC.?

Front passenger's weight sensor check:

Front passenger's weight sensor check

?1.	Substitute a known-good front passenger's weight sensors as an assembly.

?2.

Reconnect the following connectors.

SRS unit connector B (39P)

Front passenger's weight sensor (front outer side) 3P connector (on the front passenger's seat wire harness)

?3.	Reconnect the negative cable to the 12 volt battery.

?4.	Clear the DTCs with the HDS.

?5.	Turn the vehicle to the ON mode, then wait for 10 seconds.

?6.

Check for DTCs with the HDS.

DTC Description	DTC
B00C1-87 No signal from the front passenger's weight sensor (front outer side)

Is DTC B00C1-87 indicated?


	YES

The front passenger's weight sensor is OK. Faulty SRS unit or poor connection at SRS unit connector B (39P) and the SRS unit. Check the connection; if the connection is OK, check for any authorized service information related to the DTCs or symptoms you are troubleshooting or replace the SRS unit.?


	NO

Faulty front passenger's weight sensor. Replace the front passenger's weight sensors as an assembly.?